Wednesday, November 12, 2008

Potential Benefits and Costs of Speed Changes Assumption

1. The current speed limits on freeway standard and other divided rural roads are 110 km/h for cars and light commercial vehicles (LCVs) and 100 km/h for all rigid and articulated trucks, and the speed limit on undivided rural roads is 100 km/h for all types of vehicle.

2. Vehicles of each type cruise at their speed limit, so that their average speed is the same as the limit, unless their speed is reduced by slowing for curves or stopping in some parts of the road section.

3. Apart from where indicated, the rural roads are relatively straight without intersections and towns, allowing vehicles to travel at cruise speed throughout the whole road section.

4. The mix of traffic by vehicle type is the same on each class of rural road, namely 67% passenger cars, 20% light commercial vehicles, 5% rigid trucks and 8% articulated trucks, and that this mix does not vary by time of day on rural freeways and other divided roads.

5. Crashes involving material damage only, and no personal injury, were not included in the analysis of crash changes with speed, and the likely increase in these crashes with increased speeds (albeit to a lesser extent than fatal and injury crashes) was not valued. Material damage crashes represented about 16.3% of total crash costs in Australia during 1996 (BTE 2000).

6. Scenarios in which truck speed limits are lower than light vehicle limits have been analysed on the assumption that the (increased) speed differential between these vehicle types does not in itself increase crash risk or the severity of the crash outcome.

7. The changes in speed limits are assumed not to increase or reduce travel demand and traffic flows of each vehicle type on the road sections.

8. The travel time savings on the rural road sections are of sufficient magnitude to be aggregated and valued.

9. The current economic valuations of travel time, road trauma, and air pollution emissions provide an appropriate basis for analysis which summates their values, together with vehicle operating costs, in a way which represents the total social costs of each speed. In other words, the current valuations are an appropriate basis for ‘trading off’ these tangible and intangible values of each impact. (Results for some alternative valuations are also presented).

10. Assessment scenarios involving variable speed limit systems do not include any estimates of capital and maintenance costs for the systems.

11. Illustrative traffic volumes used in the analysis were 20,000 vehicles per day for freeways, 15,000 for divided highways and 1,000 for undivided roads.

Thursday, November 6, 2008

Bicycle helmets to effective preventing head injury

Bicycle helmets have been proven to be effective in preventing head injury. Based on the research findings, it is possible to list the proven attributes required for an effective helmet design. The major research study supporting the factor is appended to the finding, often the attribute will have been mentioned in several studies.
  • A helmet must be worn properly to be effective, Attewell et al (2001);

  • Helmets are very effective in preventing skull fracture, but less effective in preventing brain injury, Henderson (1995).

  • The helmet must remain on the head during the crash, Williams (1991);

  • The helmet must remain in position during the crash, Williams (1991);

  • The helmet must have the maximum possible coverage of the frontal and temporal areas of the head, Williams (1991), Cameron et al (1994) and McIntosh et al (1998);

  • The helmet must have adequate energy attenuation characteristics, for a variety of impacted surfaces, including flat, blunt and sharp, Smith et al (1993);

  • A drop energy requirement of between 1.5 and 2.2 metres appears to be adequate, Williams (1991) and Smith et al (1993);

  • The criteria for the energy attenuation test should be in the region of 200g, McIntosh et al (1998);

  • The helmet must retain its integrity during the impact, Ching et al (1997) and Williams (1991);

  • The helmet must be retained, in case of a second impact, Williams (1991) and Smith et al (1993);

  • A helmet with a hard shell appears to offer better protection from severe brain injuries, Rivara et al (1996);

  • Severe brain injury occurs more often in impacts with other vehicles, McDermot et al (1993);

  • The helmet for a young child needs to be different than for an older child or adult, Corner et al (1987).
Based on the review of the helmet effectiveness literature, there are several aspects of the helmet performance immediately before and during a crash, which need to be considered when reviewing the adequacy of a standard. These are grouped here into three requirements with a short explanation (with the related tests from the standard):

1. The helmet must be worn. A helmet must be worn to have any effect, must be attractive and comfortable for the wearer to be willing to wear it.

2. The helmet must remain in place during the crash. The retention system must be capable of keeping the helmet in place during the events immediately before (dynamic stability) and during (retention system strength) the crash.

3. The helmet must have adequate energy attenuation. The helmet must be capable of attenuating the impact to minimise injury. The helmet must cover the appropriate areas of the head; especially the frontal and temporal areas (test coverage). It must not disintegrate from the impact (helmet integrity) and must be capable of adequately minimising injury to the head resulting from impacts with different types of objects (energy attenuation and load distribution). The helmet must continue to remain in place on the head for a possible second impact (order of testing).

Friday, October 31, 2008

Analysis for Heavy Truck Crashes at 500 to 1499 Kilometres

In 2001, National Transport Insurance Ltd (NTI) volunteered to forward heavy truck crash data to the Australian Transport Safety Bureau (ATSB) for analysis. This report looks at NTI truck crash claims for 1998 to 2002. In an attempt to capture crashes predominantly involving the long-distance truck fleet, the analysis was confined to incidents where trucks were at least 500 kilometres outward distance from base. To eliminate the straggle of crashes at very long distances from base, a cut-off point of 1499 kilometres outward distance from base was used.

The NTI data show that approximately:

  • 88 per cent of NTI crashes occurred within 500 kilometres from base;

  • 2 per cent occurred at distances of 1500 kilometres or more; and

  • the remaining 10 per cent of crashes, of which nearly three-quarters were on an outward leg of a trip, were in the 500-1499 kilometres from base range.

Knowing the outward distance from base means that it is possible to roughly estimate the number of hours a truck had been on the road prior to the crash.

The NTI data did not include details of injuries - fatal or otherwise - sustained by anyone involved in the crashes; therefore, for the purposes of this paper, any crash that incurred a claim of $10 000 or more has been defined by ATSB as a major crash.

Over the 1998 to 2002 period:

  • 38 per cent of NTI truck crashes in the 500-1499 kilometres outward distance from base range fell into the major crash category.
  • Peaks in major crashes occurred at 900-999 and 1100-1199 kilometres outward distances. For all crashes (ie. major plus non-major crashes), peaks occurred at 900-999 and 1200-1299 kilometres outward distances, although in 2002 a shift had begun to manifest whereby crashes had declined at 900-999 kilometres and increased at 1100-1199 kilometres outward distance from base.
  • The majority of crashes occurred during the day.
  • 60 per cent of major crashes occurred during the day, and
  • 70 per cent of all crashes occurred during the day.

For both major and all crashes, the greatest proportion of crashes occurred during the morning quarter - 6am to noon - of a full day. The hours between 5am-7am appear to have been a particularly critical time for major truck crashes in the most recent two years of the data set, although there was also a noticeable peak at 10am in 2002, and at 7pm in 2001. Over the most recent three years, a shift in the time sector of major crashes was apparent.

By 2002:
  • major crashes in the noon-6pm sector had halved (falling from 20 to 10 crashes), and
  • major crashes between midnight-6am had almost doubled (increasing from 11 to 20 crashes).

For major crashes, the dominant crash types were:

  • Ran off road (28 per cent), followed by
  • Hit third party in rear (12 per cent).

The two dominant crash types were reversed in all crashes, whereby:

  • Hit third party in rear was the most predominant (22 per cent), followed by
  • Ran off road (14 per cent).

The group of crash types gathered together to loosely form the possible fatigue-or-speed related crashes (Ran off road, Failed to take bend, Rolled due to driver error, Driver fatigue, Head on collision and Excessive speed) accounted for:
  • 52 per cent of major crashes; and
  • 27 per cent of all crashes.

Most rear end or failure to give way collisions (82 per cent) were not major crashes and most occurred between 6am-6pm (83 per cent). Similarly, the majority of turning, merging and lane changing incidents (87 per cent) were not major crashes and most occurred between 6am-6pm (77 per cent). Approximately half the collisions with animals or trains, jackknife or tyre failure incidents were major crashes and almost half occurred between 6am-6pm. Most of the crashes involving animals occurred overnight particularly between 6pm-midnight. Cattle were involved in well over half the major crashes with animals.

Looking at the possible fatigue-or-speed related crashes:

  • over three-quarters of these were categorised as major crashes;
  • nearly 60 per cent of all possible fatigue-or-speed related crashes occurred between 6am-6pm, and over half of these crashes were Ran off road crash type; and
  • the most critical time for possible fatigue-or-speed crashes appeared to be between 3am-8am.

Interestingly, while the number of all crashes in the 500-1499 kilometres outward distance range decreased substantially in 2001, the possible fatigue-or-speed related crashes peaked in that year. That is, during 2001 the possible fatigue-or-speed related crashes, on average, increased slightly while other crash types reduced in volume. Possible fatigue-or-speed related crashes were more predominant during the months of August to December with a noticeable peak in August.

The majority of all crashes in the individual freight carrier categories occurred between noon-6pm, the only notable exception being Tipping crashes, which occurred predominantly between 6am-noon. However, if looking at only major crashes, the majority of crashes for most of the different freight carrier categories occurred in the 6am-noon sector.

It would appear that in truck crashes where driver fatigue was assessed as being implicated, the later in the day that the trip began, the shorter was the distance covered prior to the crash.

Monday, October 20, 2008

Road Deaths Australia, Monthly Bulletin; April 2008

Road Deaths Australia is a monthly bulletin presenting the latest fatal road crash data as well as recent historical comparisons. It is produced by the department using monthly data supplied by the eight states and territories.
  • There was a total of 113 road deaths in April 2008.
    - this is an 18.1 per cent decrease from the April 2007 figure.

  • There have been 474 road deaths in 2008 to the end of April.
    - this is a 12.5 per cent decrease from the same 4 month period in 2007.



Monday, October 13, 2008

Road transport documentation required with applications

As part of their application the operator must give a brief overview of their operations and must provide the following details:
  • The name, ABN and bus operation licence/accreditation of the operator who is applying;
  • Evidence of an existing contract between the operator and a state/territory to provide school bus services on a route defined as regional or rural;
  • Details of any routes serviced by the operator that have been assessed under the voluntary National Guidelines for Risk Assessment of School Bus Routes or, where they have not been so assessed, details of routes serviced by the operator containing roads with speed limits greater than 80 km/h;
  • Details of any other aspects of the serviced routes that could be relevant to the assessment of the operators application (e.g. narrow and steep terrain);
  • The VIN(s), the Identification Plate Approval number(s) (for the purposes of the Motor Vehicle Standards Act 1989) and a copy of registration documents, where available, of the nominated bus(es);
  • Evidence that the buses nominated under the subsidy program have been approved by a state/territory as suitable to provide the services specified by the school bus contract noted above;
  • The nature of the work to be undertaken and the costs involved, including any quotations to undertake the work;
  • The amount of assistance requested (up to $25,000 per eligible bus);
  • Details of any existing funding provided by state/territory programs for any of the buses nominated.

Tuesday, October 7, 2008

Aviation Statistics AR-2008-057, Aviation transport Statistics: 1 January 1998 to 30 June 2008

The ATSB has changed the way in which aviation transport statistics are presented. This report represents the first in an ongoing series of reports provided in the new format. The report encompasses a rolling 10-year reporting cycle and replaces all individual spreadsheets previously available.

This report provides aviation accident and incident, collectively termed occurrence, data for the period 1 January 1998 to 30 June 2008. This data was provided to the Australian Transport Safety Bureau by 'responsible persons' as defined in the Transport Safety Investigation Regulations 2003, Part 2.5. The data excludes non-VH registered operations in the sports aviation category, and is current as at 30 June 2008.

The data will be adjusted quarterly to reflect new information received during the reporting period

Monday, September 29, 2008

Endeavours of Ministry of Surface Transport

Around 70,000 lives are lost and about3.50 lakhs persons are injured on Indian roads every year. These apart from causing enormous misery and hardship to those affected. Inflict a heavy monetary toll on the economy. According to a rough estimate the total economy loss to the country on account of road accidents is estimated to be about Rs. 5000 crores every year which comes to about 0.5 % of the Gross Domestic Product of the country. This does not include the cost of pain, grief and suffering by the families of the victims.

The Ministry of Surface Transport has taken a number of steps in order to improve road safety in the country. These include widening and strengthening of roads, improvement of intersections, replacement of level crossing with road over / under bridges, provision of retro-reflective road signs and thermoplastic road marking and setting up wayside amenities on the highways for passengers and vehicles. The Ministry is also introducing amendments to the Motor Vehicles Act with a view to tightening the provisions relating to driving skills and fitness of vehicles including enhancement of penalties for various traffic offences.

On the educational side the Government has been undertaking various publicity campaigns to inculcate road safety consciousness among various sections of road users. These include publicity through print and electronics media like news paper, T.V. and radio, screening of cinema slides, computerised animation display, display on colour railings, advertisement through closed circuit T. V. system, distribution of calendars, tin plates, Road Safety Games, wall paintings depicting road safety messages etc.