Thursday, July 31, 2008

Check trailer brakes and breakaway protection

  • For trailers with a gross trailer mass (GTM) in excess of 2 tonnes, the trailer service brakes do not operate immediately the trailer service hose coupling or connection is disconnected from the towing vehicle and do not remain fully applied for at least 15 minutes;
  • A truck trailer interconnecting flexible hose and coupling is not properly mated or secured;
  • For trailers with a GTM in excess of 2 tonnes the trailer brakes are not capable of being applied and released from the normal driving position;
  • Any trailer having brakes which are air or vacuum assisted is not fitted with a reservoir that is protected by a check valve;
  • Any trailer having brakes which are air or vacuum assisted is not built to provide a visible or audible warning to the driver of the towing vehicle, while the driver is in a normal driving position, of a lack of air or vacuum.

Road Infrastructure

The Department continually monitors the condition of roads throughout the province for the purpose of planning, maintenance and reconstruction. In 2006, approximately 60 % of the paved road network was measured by “road roughness testing”, dynamic cone penetration (DCP) and evaluation of skid resistance.

The Departmental technical centre also conducted research with a view to locating mapping and evaluating material sources for road building in the province. A number of material sources have been tested for suitability.

The Department continues to use the bridge management software programme developed by the CSIR to manage 1,610 bridges and 2,008 culverts in the province. In 2006 a visual inspection of 323 bridges and 267 culverts was conducted.

The department uses the Road Management System (RMS) to provide a scientific basis for evaluating the condition of paved and unpaved road networks. Pavement Management Systems (PMS) and Gravel Road Management Systems (GRMS) are also used.

Wednesday, July 30, 2008

Engine Shutdown

Engine shutdown is the automatic or voluntary shutoff of the tractor engine after a certain amount of time. Engine shutdown can be as simple as a corporate “shut down” or “no idle” policy or it can be more complex with the use of electronic devices or software encoded onto the engine control chip that automatically shuts the engine down. Engine shutdown works most effectively when combined with a comprehensive driver training program and driver incentive program. For a partial list of automatic shutdown devices.

Reflashing involves reconfiguring the engine control chip with new software that recalibrates the tractor engine. This recalibration is meant to lower nitrogen oxide (NOx) emissions by slightly modifying the combustion parameters within the engine. This strategy applies to certain engines built by seven different engine manufacturers (Caterpillar, Cummins, Detroit Diesel, Mack, Renault, Navistar/International & Volvo) between the years of 1993 and 1998. Please note that as of March 2004, the California Air Resources Board (CARB) has mandated the reflashing of medium and heavy duty diesel vehicles in the state of California, on a phase-in schedule, at no extra cost to the vehicle owner. For more information, please refer to the CARB rule at

Tuesday, July 29, 2008

Check windscreen wipers, demisters and washers

  • The windscreen wipers are inoperative on any speed;
  • Wiper blade rubbers are cracked, hardened, frayed, curled, torn or missing;
  • Windscreen washers are inoperative or incorrectly aimed (where applicable);
  • Windscreen demister is inoperative or does not blow air onto the windscreen (where applicable);
  • The windscreen washer is not able to be operated from a normal driving position.

Monday, July 28, 2008

Check headlights

  1. Headlight reflector is tarnished or peeling to the extent that headlight performance is impaired;
  2. Headlight lens is cracked or broken;
  3. Headlight assembly is not secured or is out of position;
  4. Headlight does not show while light.

Friday, July 25, 2008

Check number plates

  1. Any number plate is obscured, for example by a towing attachment, goose neck or tow ball;

  2. Any number plate cover is tinted, reflective, rounded or bubble like;

  3. Any number plate is not issued or approved by the State or Territory Road Transport authority, is damaged or faded to the extent that the registration number is not legible from a distance of five metres;

  4. The number plates are not substantially parallel to the vehicles axles.

Thursday, July 24, 2008

Check wheel/ rim fasteners

  1. The wheel nut does not fully engage the thread of the wheel stud or the fitting of the wheel nut does not match the taper of the wheel stud hole;
  2. Any hub has missing, cracked, stripped or broken wheel mounting nuts, studs or bolts;
  3. Fasteners are not of the correct type for the wheel being used or allow a rim to slip on its spider.